• 振动摩擦焊接机
  • 超音波焊接
  • 振动摩擦焊接机

What operating ultrasonic welding confidential note of it

Contact us

上海金沙国际平台登录_js9905com金沙网站

电话:021-64683698

传真:021-64683698

邮箱:shang--rong@163.com

网址:www.shang-rong.com

公司地址:上海市徐汇区中山南二路158号

工厂地址:上海市奉贤区青村镇品星路278号


Your current position: Home >> NEWS >> Industry News

What operating ultrasonic welding confidential note of it

Date:2014-09-24 00:00 Source: Click:

What is now before construction operations are particular about security, then welding ultrasonic welding machine handle to be ready for it

     First to open the transducer housing screws, remove the transducer Used soft cloth on the table after a fixed vertical vise, then unscrew the connections are screw counterclockwise, remove the receiver welding fixture with a wrench. Spin on the change and then remove the handle after welding mold tooling connections are screw screw foreign body, apply a small amount of butter on the edge of the screw holes with a soft cloth on a table vise clamp transducer (screw connections are not too tight).

     Then put down the handle cover is fixed by welding fixture mounted on a base inscribed within the mark, put a closing lid handle in a fixed tooling, press [decline ultrasonic welding switch] makes welding mode fall completely covered cover on the handle, after the fixed positioning screw fixed tooling sides respectively, hold the handle positioned at the four core against the handle screw and the cover of the four cores, release [ultrasonic welding down switch].

So ultrasonic welding machine in the welding operation we have to pay attention to what it

     Take a receiver equipped with a handle under cover, under the handle cover check whether scratches, smears and other negative phenomena, after passing the examination, being put in the ultrasonic welding tooling, press the green button ultrasound group riding to work, after the end of the work, such as welding machine, remove the handle checks, welding should be tightened on the receiver, and whether there are burns, welded in place, traces of oil and other undesirable phenomena, while the foam pad on the desktop bags under tapping 2-3 , the receiver should be no loosening, after passing the examination, and the receiver are placed should be no loosening, each batch of 10 pre-production and production per hundred inspections by the above requirements.

     Ultrasonic welding machine for welding is prohibited in any part of the body below the welding mold, avoid the ultrasonic vibration and high pressure heat damage, ultrasonic welding machine in the welding operation, such as an accident emergency stop switch is pressed, the machine immediately restore the original state, stop working. After the accident shall turn right to exclude emergency stop switch, causing it to pop, ultrasonic welding machine can only continue to work, appear abnormal or welding equipment is not working properly, immediately stop work on-site management staff to reflect


Related Tags:超音波焊接

  • Service
  • Service
  • Service
  • Service
二维码

Scanning

Share
Welcome to our message
Please enter the message, we will contact you soon.
Name
Contact
Phone
Mobile number
XML 地图 | Sitemap 地图